
11
5.8 Cutting Test
• To perform the cutting test in the offline mode, press the Test button; the
plotter then cuts a rectangle in the inserted vinyl at the currently stored zero
point.
• You can check the adjustment of the blade holder as well as the contact
pressure with this cutting test. The material inserted should be cut cleanly and
straight during the cutting test; the backing material should not be damaged.
• If the backing material has been cut through, either the contact pressure is set
too high or the blade or blade holder is adjusted incorrectly. Change these
adjustments and perform the cutting test again.
• Also readjust if the vinyl was cut imprecisely or to an insufficient depth.
Komentáře k této Příručce